Manuals and instructions for everything

why is my brake pedal going to the floor

SYMPTOM SUMMARY The brake pedal goes to the floor when pressed. There may be little or no braking action when the pedal is depressed. The Red Brake Warning Lamp may be illuminated indicating a system failure. USUAL CAUSE Very low brake fluid or a defective Master Cylinder is the usual cause of this symptom. The master cylinder pressurizes the brake system when the pedal is depressed and provides hydraulic fluid to each of the wheels to apply the brakes. The braking system is designed to illuminate the Red Brake Warning lamp when a hydraulic failure is present. DIAGNOSIS If you have just performed other brake work on the vehicle and the hydraulic system was opened, the most probable cause is air in the system. The system will need to be bled according to manufacturers recomendations. The first step in diagnosing this symptom is to inspect the brake fluid level at the master cylinder. If the fluid level is low, the system will need to be inspected for leaks. The calipers, wheel cylinders (on drum brakes) will need to be inspected. Brake pads that are completely worn can cause low fluid level. This is a result of the caliper pistons being completely extended, causing most of the brake fluid to reside in the calipers. The brake pads and shoes (if equipped) should be inspected for signs of brake fluid contamination indicating a leak.

Inspect the calipers for leaks at the rubber dust boot around the pistons. The dust boot on the wheel cylinder will have to be pulled off slightly to inspect for leaks. Check the hydraulic lines, proportioning valve and flexible hoses for leaks. Inspect the master cylinder where it mounts on the brake booster for signs of leaks. Loosening the master cylinder retaining bolts and pulling it back slightly, will usually result in detection of a leak if present. If leaking, the fluid will run out of the mating surfaces. In this case, the master cylinder will require replacement. If there are no fluid leaks present or the fluid level is normal and the brake pads and shoes (if equipped) are in good condition, the most probable cause of the symptom is a defective master cylinder. Determining the cause of the failure will dictate what corrective action is necessary. If the hydraulic system needs to be serviced, as with replacement of the master cylinder, it will need to be bled of all the air once it has been resealed. Refer to the manufacturers specific bleeding procedures. PRECAUTIONS, TIPS, and NOTES
If the vehicle is equipped with ABS, certain ABS components can cause this symptom.

In this case, the system should be serviced according to manufacturers recommendations. If servicing the hydraulic system, use caution not to contaminate the system with dirt, debris or water. Always use the recommended brake fluid DOT rating. This information can be obtained from your owners manual or off the cap on the master cylinder. (Lance owned his own auto repair shop for 30 years before retiring in 2006. ) Wow! PThis one gets your attention real quick. We have always said I am not happy when my car will not start, But when it does not STOP P it s all bad. P So what has happened. First of all, you may have been fortunate to have a red brake light come on, before your brake pedal became spongy or made its way to the floor when you attempted to stop. Don t count on it. If the red brake light is on and your brake pedal is OK, the brake fluid level is most likely low and adding the correct brake fluid should turn the light out. The next step in this case, would be to have the brakes inspected for wear and a brake fluid leak. Ok, on to the WOW factor. Most of the time, when your brake pedal goes to the floor, a steel brake line has rusted through. This allows the fluid to spew out there instead of applying the brakes.

Next up, a brake component has failed causing the brake loss. A comforting fact. Today, the cars master cylinder fluid reservoir has a divided container. This reduces the odds you will lose all of your brake fluid at once, allowing you to have some brake even when your brake pedal goes to the floor. Safe to drive? PPNOOO! PPGet you home ( if no panic stops are required and you use your common sense allot ) Probably. To be smart and safe, have your car towed is best. The other reason this light is there, is to tell you when your Parking Brake is on. Releasing the brake should turn the light off. If it does not go out, there may be a problem electrically or the parking brake is stuck part way on. An easy check, move the car forward slowly and see if the car comes to a stop fairly quickly. If so, the parking brake is most likely still on. If you still have your doubts, drive the car a few miles and place your hand near the center of the rear wheel. If you feel allot of heat, odds are the parking brake is hanging up or you have another issue on that wheel needing attention. PAlso this light should come on when the cars starts and go quickly. If you would like to receive our blog, simply sign up at the rightP.

  • Views: 158

why does my car leak brake fluid
why does my brake pedal slowly go to the floor
why does my brake pedal go to the floor
why does my brake pedal go almost to the floor
why does my brake pedal go all the way down
why does brake light came on while driving
why do you need to bleed your brakes